Steps:
- Remove the original screws
- If the screw will not back-out, apply pressure with a flathead screwdriver to push while unscrewing
- Check the fit and find a location for a new hole
- Start the screw by applying pressure to drive the screw into the grey bottom plate and hold the white bottom of the shell against the screw tip with pressure to get the screw to grab. In the video below, I already started the screw through the grey plastic.
- Tighten slowly drawing in the white bottom of the shell into the grey bottom plate until the alignment is correct with the draw. Check your alignment. It is okay yo have gaps between the plate and the bottom of the shell. It will provide you a more aesthetic front.